Firstly the maintenance manual must be remembered.
How to do it every day is good for the crimping machine and we should stick to it every day.
First of all, the surface of the crimping machine to clean up, the machine mold stamping process: By the motor through the pulley, drive the input shaft, through the pinion, large gear, drive the upper shaft, through a set of CAM mechanism to drive the sliding seat with the upper mold up and down movement, to achieve pressure tile. The transposition of the workbench is made by the Gear group mounted on the upper shaft end, the transmission pin gear, the groove wheel mounted on the six square wheel shaft to achieve the division positioning, at the ends of the upper axis each is equipped with a back cam mounted on the same shaft and the suppression cam conjugate, through the positioning rod and the positioning disk to achieve the precise positioning of the lower In the left and right sides of the chassis, the installation of a lubrication pump, the machine works through, the tubing to each friction moving part of the transmission of lubricants.
It is strictly forbidden to work beyond the minimum closed height, that is, the upper sliding bottom surface to the minimum distance of the working surface 290㎜ requires the height of the upper and lower die die Plus, the upper and lower pad thick bottom plus the thickness of the tile billet, does not allow more than 290 ㎜, the manufacture of molds should be designed according to this requirement Always pay attention to observe, sliding the box and the height of lubricating oil in both sides of the body. Equipment should be wipe regularly, keep clean, do not have muddy water.