Safety operation procedure for steel bar straightening and cutting machine
1, before we use steel straightening and cutting machine ,we must check the blade if blade has cracks or not, make sure blade fixing screws are fastened. The shield on the side of the pulley and the protective cover of the transmission part are complete.The fuselage shell should be grounded so as not to leak and hurt people.
2, when steel straightening and cutting machine does not reach the normal speed, do not cut material.When we Cut off material we should look at the blade between the gap, hands clenched steel bar quickly sent, and to the side of the blade slightly pressed tightly, do not allow two hands on both sides of the blade to lean over the feed.
3, it is forbidden to cut off the diameter of more than the mechanical brand requirements of steel bars and red steel bars.the Steel bar section must be converted when multiple steel bars are cut off once.
4, such as cutting off low alloy and other special steel bars, we should replace the high hardness blade, at the same time according to the machine name specified diameter for conversion.
5, when we cut off the short material on our steel straightening and cutting machine, the length of the holding end must not be less than 40 cm, close to the blade between the hand and the blade to maintain a safe distance of at least 15 cm.
When the length of the cut steel bar is less than 30 cm, the short head must be pressed with a casing or fixture before cutting to prevent the rebound from hurting the person.
6, when cut off the longer steel bar,we should be set up to help the steel bar, the reinforcement personnel should be consistent with the mastery of the Machine personnel action, and follow its command, not arbitrary pull, drag.
7, mechanical operation is strictly prohibited + by hand directly remove the knife near the edge of the broken head and debris.Steel bar Swing range and near the edge of the knife, non-operators are not allowed to stay.
8,when found that the mechanical operation is not normal, there are different sound or blade skew, loosening, cracking, should immediately power off parking. It is strictly forbidden to overhaul the running machinery.It is strictly forbidden to overhaul the running machinery.
9, when we finished the work on steel straightening and cutting machine,machine should be brakes power outage, lock the switch box, and clean the work place, machine wipe and add grease.
Email:sales@metalwiremachinery.com
Mobile/whatsapp:+8615131132009