Reason for failure cutting of steel bar straightening and cutting machine
This problem occurs, first observe will not out of the knife, if not out of the knife, should be the length of the steel bar cut is not correct, if the knife and cut the continuous steel bar, should be insufficient pressure, or control the line of the knife problem, it may also be the steel bar straightening cutting machine cutting knife contact is not tight
So why should we adjust the steel bar straightening cutting machine, let's take a look at:
If the pressure of the cutter is not reached and the continuous steel bar is cut, we need to make appropriate adjustments in accordance with the instructions, to observe whether the gap between the upper and lower blades is too large, the gap should be kept at around 0.2mm.
If the hardness of the steel bar is higher, it will speed up the wear of the cutter, pay attention to regular inspection and replacement. The above is cut knife out of the knife and cut the continuous reinforcement of the solution, if the cutter does not out of the knife, check whether the set cut length is wrong, or check whether the control cutter line is faulty.
Email:sales@metalwiremachinery.com
Mobile/whatsapp:+8615131132009