Chain link fence machine operation guidance
1).Open water pump
2).Put wires on the coil stands and put the coil stand steady
3).Install chain link fence machine mold.
4).Putting wires into the mold,a wire must be a pitch.
5).Manual netting,after a wire finished bend,put the second wire.
6).When two wire finish bend,Put the knife in the vertical,and then try to cut the wire ,if it a little off,please adjust platform.
Note:Don't put the hand on the knife when cutting wire,lest danger occurs
7).Then let one wire fished bend,and then put the wire on the positioning pin,so make the mesh stabled.
8).At the same time ,ensure each wire positioning is consistent
9).Manual netting,when reach 1m,put the net on the winding reel(on the weaving machine).
Note :reel must be stuck on the two wire intersections.
10).Then adjust the edge,all around ,until adjust to the best position.
11).Then then machine can normal operation.
Note:Nets must tighten
12).Computer parameter setting ：turn on the power at the moment
First ：According to the mesh width adjustment parameters，Press SET to automatically adjust the length of the set every word is bent,by this way, when adjust well press enter.
Second , Automatic speed setting,After pressing the SET key to set the optimum speed and press ENTER
Third : Automatic subtraction time: that is the start time and stop time.
Fourth: rolling mesh time : Generally do not move.
Fifth : After the completion of the commissioning and check the machine in good condition,Can be put into production,When the mesh accumulate to a certain extent quantity, Artificial pull Mobility rolled up piece to a specified location,Demolition of a wire tie up
13）.When stop working, the power shall be delayed closure, Let the cooling system work again for a period of time
14）.manual netting speed generally don't need to adjust
15).counter set is the length of the mesh
Email:sales@metalwiremachinery.com
Mobile/whatsapp:+8615131132009
Web:www.metalwiremachinery.com